How to Reset Golf Cart Battery Charger: Troubleshooting Guide

Got a lithium golf cart charger acting up? Let’s cut through the noise. Below is a no-BS guide to fixing common issues with BasenBattery’s 48V LiFePO4 chargers, including the Anderson Plug, Club Cart, EZGO, Yamaha, and Universal Alligator Clips models.


The Quick Reset Method

All BasenBattery chargers (even the Universal Alligator Clips model) share a universal reset sequence:

  1. Unplug the charger from the cart and wall.
  2. Wait 10 minutes (lets capacitors discharge).
  3. Reconnect cart first, then wall power.
    Why this works: Resets the charger’s internal logic board. Tested on Yamaha G29 and EZGO TXT models.

Fault Codes & Blinking Lights

Solid red + blinking green on Club Cart/EZGO RXV chargers?

  • Translation: “I see voltage, but something’s blocking full charge.”
  • Fix: Check battery terminals for corrosion (common with lithium conversions). Use dielectric grease on the 58.4V output plugs.

Rapid red flashes on Yamaha G19-G22 chargers:

  • Translation: Overvoltage/undervoltage lockout.
  • Fix: Verify cart voltage with a multimeter. Basen’s 48V 105Ah lithium packs should sit at 53V–54V when idle. If lower, check for a dead cell.

Overheating? Blame the Fan (Usually)

All 18A Basen chargers have temp-controlled fans. If your Anderson Plug or Universal model feels hot:

  1. Listen for the fan – No whirring? Dust clogging vents (common in garages). Blow compressed air through side slots.
  2. Check ambient temps – These chargers throttle power above 113°F (45°C). Park carts in shade.

“Charger Not Recognizing My Cart”

Common with aftermarket lithium swaps. For EZGO TXT and Club Cart models:

  1. Bypass the OBC (Onboard Computer): Lithium chargers don’t need it. Disconnect the OBC’s gray wire.
  2. Test with alligator clips: Basen’s Universal model bypasses cart wiring entirely. Clip directly to battery terminals.

Real-World Test: Simulate a Fault

Basen’s chargers auto-diagnose. Try this on a Yamaha G29:

  1. Unplug the DC output while running.
  2. Watch the LED cycle red → yellow → green.
  3. Reconnect within 2 mins – charger resumes.
    Takeaway: If it doesn’t recover, the MOSFETs are likely fried (warranty claim time).

When to Throw In the Towel

Basen’s 2-year warranty covers:

  • Fan failures
  • Glitchy voltage regulation
  • LED display bugs
    Exclusions: Physical damage, water ingress (those IP65 ratings only go so far).

Why These Chargers?

  • No “dumb” modes: Unlike lead-acid chargers, Basen’s models auto-adopt charge curves for their 48V 105Ah lithium packs.
  • Anderson SB175 Connectors: Handle 18A without melting (a notorious issue with knockoff plugs).
  • US Stock: 48hr replacement for LA, TX, FL warehouses.

Bottom line: 90% of “faults” are false alarms. Reset, retest, then hit up support@basengolfbattery.com if all else fails.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses cookies to offer you a better browsing experience. By browsing this website, you agree to our use of cookies.